TRG Catalog

23

R ETROFIT S NAP - IN G ASKET R ETAINER

Gaskets

• Mounts flat to the door • Gray rigid PVC extrusion • Surface mount retainer can be screwed to most doors allowing the use of most single Dart style gaskets.

• Retainer will add 9/32" thickness to the gasket area and will in most cases require hinges to be shimmed or a higher offset hinge. • You must have 1-1/4" reveal around the outer edge of the door (where the existing gasket sits) to insure that the retainer will lie flat. • Screws can be countersunk into the retaining groove for mounting. The gasket dart may be notched at the screw heads to allow proper fit. • If shipping via UPS, retainer must be cut.

ITEM #

WIDTH

HEIGHT

LENGTH

19-10-516R

1-1/8"

9/32"

120"

R EPLACEMENT S NAP - IN G ASKET R ETAINER

• Replacement gasket retainer available in 8' lengths • Easy replacement • Gray rigid PVC extrusion • Used in new doors or replaces existing broken retainer (Doors should be foam-filled)

A

B

Inside of Door

Outside of Door

ITEM #

WIDTH

HEIGHT

LENGTH

19-10-516T

7/8"

3/8"

96"

How to install a Gasket Retainer

• Remove Old Track: Slit the track with a razor knife down the center of the groove. The track will lift out in two pieces. • Install Replacement Track: Cut the track to length with mitered corners. Slide the inside pan of the door into the slot on the "A" side of the track in the diagram above. With the track in the proper position in the corners, push down on the "B" side of the track to snap into place.