TRG Catalog

77

Reach-In Hardware Terminology (cont.) • Offset: This applies to hinges. Reach-in hinge offsets are measured differently by different manufacturers. We will refer to “total depth” of the hinge when there is confusion. This refers to the measurement from the back of the hinge (where it touches the unit) to the front.

Reach-In

Total Depth

• Straight Handle: ¬2EFERS¬TO¬A¬VERTICAL¬LATCH¬RUNNING¬mUSH¬ with the edge of the door. This provides additional protection from abuse. • Offset Handle: Refers to a vertical latch with a “dog leg” lever. The lever extends past the door allowing easy access in tight situations. • Screw Centers: These measurements are helpful in identi- fying hardware. The measurements are taken from the center of the screw holes. • Surface Mount: Refers to latches that mount horizontally on the front face of the door.

Total Refrigeration Gaskets Call us at 1.800.452.4275